How to Replace a Nissan Juke Spare Key

Nissan Juke is an attractive and fun hatchback that has unique engine design. It's noisy, but it's enjoyable to drive.

Replace the battery for the key fob of your Nissan Juke every two years or when it's at a low. You can do it yourself, however you'll require some tools.

Dead Coin Battery

If your Nissan Juke key fob has stopped working the first thing you should be sure of is the battery inside. It may be dead and require to be replaced, which is a simple fix that will take only about a couple of minutes. Flip the fob upside down and you'll be able access the tiny latch/release located at the back. Remove the battery from the old one and then insert the new one, making sure that it's facing downwards in the fob. Line up the two halves of the fob with care.

The fob needs to be cleaned if it was exposed to water prior to being able to install a new battery. This can be accomplished using a paper towel, isopropyl alcohol or electronic cleaner, and then let it dry completely prior to re-inserting the battery.

The key fob has to be connected to the vehicle to start it, which can be done by following the instructions in the owners manual or using an OBDII scanner. The most likely reason why the key fob stopped working is because it wasn't linked to the car. It is also possible that the fob is equipped with malfunctioning chips, but this is rare. A new receiver module might be required in this instance. If this is the scenario, it's going to need to be replaced by a certified technician.

Water Damage

Key fobs are powered by batteries and the batteries must be replaced every two years, or as soon as your car stops responding when push the "start" switch. The keys' rubber seals keep out water, but submerging a key fob into the pool or ocean can damage the chip's electronic. If this happens, you will require a new key from Nissan or an automotive locksmith.

It's possible that the computer has lost connection with the key fob This could be due to a number of reasons. It can be fixed by restarting the car. If the "Key ID error" message still appears, you will need to contact Nissan for assistance.

The three most common causes of this problem are dead key fob batteries as well as a key that is not programmed and a damaged or defective key fob that has been damaged or broken. The first two are fairly simple to fix, while the latter is a bit harder to diagnose and repair in the moment, but it can usually be fixed by a little patience. Compare Nissan Key Replacement prices in your area with WhoCanFixMyCar, and book your repair online. It only takes a few seconds and you can review customer reviews from local garages, Nissan car mechanics and dealerships before you decide.

Faulty Chip

The key fob on your Nissan Juke has a special chip that transmits a signal to the car whenever you turn it. If the chip is damaged it could cause the key to stop working. If this happens, the problem can only be solved by replacing the key. Your Nissan Juke key could be faulty for several reasons, including water damage or a dead battery for the coin.

If your key fob stopped working after a soak in the wash or even a bath, you must check the chip for water damage. Make sure the metal retainers are in good shape and the chip isn't exposed to water. If you notice any indications of water damage, try taking off the battery and then wiping the electronic component with isopropyl alcohol, or electronic cleaner.

If the chip is damaged, you'll need to contact your local locksmith or dealer. They will require the year the make, model, and year of your vehicle to find the replacement. Also, you will need to write down the VIN (Vehicle Identification Number) so that the dealer or locksmith knows precisely which key you own. This will allow them to look up the correct key code and ensure that they are cutting the correct key.

Faulty Receiver Module

The key fob transmits an audio frequency signal to your car in order to perform various functions. The key fob is able to unlock your trunk while you rush to get groceries or start your car by pressing the fob's button. It can even open your windows and turn on the horn should you accidentally lock your keys in the car.

If the key fob ceases working, there may be problems with the receiver unit in the vehicle. The receiver modules are tuned to detect specific frequencies that correspond with the signals generated by the Nissan key fob. A faulty receiver module will stop your car from responding to the signal received by the key fob of Nissan.

It is always recommended to carry a spare nissan juke key fob replacement key fob in the event that the original key you have or breaks. A spare key can be programmed by a locksmith or a dealership to work with your Nissan and can save you the hassle of locking your keys in your vehicle or losing them.

If your nissan qashqai key replacement Juke's key fob was exposed to rain or clean tap water, you can resolve the issue by cleaning it with isopropyl or an electronic cleaner. If the chip is damaged you'll need to purchase a new keyfob that can be coded for your vehicle by a dealer or locksmith.